Standard Specification for Heat-Strengthened and Fully Tempered Flat Glass
NORM herausgegeben am 1.10.2018
Warum Redline?
Redline stellt eine schnelle und einfache Art dar, wie man gesamte Änderungen zwischen einer aktuellen gültigen Norm und der Vorversion vergleichen kann.
Dank Redline werden Sie sofort informiert von:
Sparen Sie Ihre Zeit und Sorgen!
Dank Redline brauchen Sie nicht mehr zu forschen, was in der neuen Norm geändert wurde! Redline spart Ihre Zeit und stellt sicher, dass Sie über Änderungen in der Norm erfahren.
Der Preis
Wenn Sie die Variante "Gültige Norm + Redline" auswählen, bekommen Sie beide Dokumente! Und das Beste ist, dass der Preis der Gültigen Norm + Redline nur ein wenig höher ist, als der Preis der gültigen Norm selbst.
Designation standards: ASTM C1048-18
Publication date standards: 1.10.2018
The number of pages: 8
Approximate weight : 24 g (0.05 lbs)
Country: American technical standard
Kategorie: Technische Normen ASTM
This specification covers heat-treated flat glass - kind HS, kind FT coated and uncoated glass used in general building construction. Glass furnished under this specification shall be of the following conditions: condition A - uncoated surfaces, condition B - spandrel glass, one surface ceramic coated, and condition C - other coated glass. Flat glass furnished under this specification shall be of the following kinds: kind HS - heat-strengthened glass shall be flat glass, either transparent or patterned, in accordance with the applicable requirements, and kind FT - fully tempered glass shall be flat glass, either transparent or patterned in accordance with the applicable requirements. All fabrication, such as cutting to overall dimensions, edgework, drilled holes, notching, grinding, sandblasting, and etching, shall be performed before strengthening or tempering and shall be as specified. Requirements for fittings and hardware shall be as specified. In heat-strengthened and fully tempered glass, a strain pattern, which is not normally visible, may become visible under certain light conditions. The support system and the amount of glass deflection for a given set of wind-load conditions must be considered for design purposes. Heat-treated flat glass cannot be cut after tempering. Heat-treated glass can be furnished with holes, notches, cutouts, and bevels. The expansion fit and porosity of the ceramic coating shall be tested to meet the requirements prescribed. Specimens for evaluation of resistance to alkali and acid shall be prepared and tested to meet the requirements prescribed.
Keywords:
edge compression, flat glass, heat-strengthened glass, heat-treated glass, surface compression, tempered glass ,, ICS Number Code 81.040.30 (Glass products)