SAE J2436

Die Annotation des Normtextes SAE J2436 :

To document test procedures and setups that address known failure modes for Accessory Drive automatic tensioners. This SAE Standard does not encompass the pulley or pulley bearing. The sample sizes and acceptance criteria should be determined by agreement between the original equipment manufacturer (OEM) and the supplier.

The failure modes to be addressed are:

Test Factors include:

NOTE: The Belt Drive Committee recommends that this spec be run using test parts that are close to the upper and lower specifications for load output and damping (tails testing).

SUBFILE: Automotive
TYPE OF DOCUMENT: Ground Vehicle Standard