Cookies
Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
ASTM A334/A334M-04a(2016)
Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service (Includes all amendments And changes 10/8/2021).
Automatische name übersetzung:
Standard-Spezifikation für nahtlose und geschweißte Carbon und Aluminium-Stahlrohre für Tieftemperaturbetrieb
NORM herausgegeben am 1.3.2016
Informationen über die Norm:
Bezeichnung normen: ASTM A334/A334M-04a(2016)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.3.2016
SKU: NS-633366
Zahl der Seiten: 6
Gewicht ca.: 18 g (0.04 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Kategorie - ähnliche Normen:
Die Annotation des Normtextes ASTM A334/A334M-04a(2016) :
Keywords:
ICS Number Code 23.040.10 (Iron and steel pipes)
Ergänzende Informationen
| 1. Scope | ||||||
|
1.1 This specification2 covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse affect on low-temperature impact properties. 1.2 Supplementary Requirement S1 of an optional nature is provided. This shall apply only when specified by the purchaser. Note 1: For tubing smaller than
1/2 in. [12.7 mm] in outside diameter,
the elongation values given for strip specimens in Table 1 shall apply. Mechanical property
requirements do not apply to tubing smaller than
1/8 in. [3.2 mm] in outside diameter
and with a wall thickness under 0.015 in. [0.4 mm].
1.3 The values stated in either
inch-pound units or SI units are to be regarded separately as
standard. Within the text, the SI units are shown in brackets. The
values stated in each system are not exact equivalents; therefore,
each system must be used independently of the other. Combining
values from the two systems may result in nonconformance with the
specification. The inch-pound units shall apply unless the “M”
designation of this specification is specified in the order.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
| 2. Referenced Documents | ||||||
|
