Cookies
Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
ASTM B911/B911M-22
Standard Specification for ACSR Twisted Pair Conductor (ACSR/TP)
Name übersetzen
NORM herausgegeben am 1.6.2022
Informationen über die Norm:
Bezeichnung normen: ASTM B911/B911M-22
Ausgabedatum normen: 1.6.2022
SKU: NS-1066041
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Kategorie - ähnliche Normen:
Die Annotation des Normtextes ASTM B911/B911M-22 :
This specification covers ACSR twisted pair conductor for use as overhead electric conductors. The conductors shall conform to the required values of equivalent size AWG, outer dimensions, nominal mass, rated strength, resistance and shall conform to the required component composition of aluminum and steel. . Tests for the electrical and mechanical properties shall be made on the component conductors.
Keywords:
aeolian vibration, aluminum, aluminum conductor, ASCR, electrical conductors, galloping, overhead conductors, steel-reinforced conductors, stranded aluminum conductors, TP, twisted pair,, ICS Number Code 33.120.20 (Wires and symmetrical cables)
Ergänzende Informationen
| 1. Scope | ||
|
1.1?This specification covers ACSR Twisted Pair Conductor (ACSR/TP) for use as overhead electric conductors (see Notes 1 and 2). Note 1:?The conductor is fabricated from two component ACSR
conductors of the same size twisted helically around each other.
This conductor is identified by the code name of the component ACSR
conductor followed by /TP or the size and type of the component
ACSR conductor followed by /TP.
Note 2:?There are registered trademark symbols that are also
used to identify the twisted pair notation. Consult cable
manufacturers for additional details.
1.2?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.2.1?For conductor sizes designated by AWG or kcmil, the requirements in SI units have been numerically converted from corresponding values stated or derived in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units. For density, resistivity, and temperature, the values stated in SI units are to be regarded as standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
| 2. Referenced Documents | ||
|
Empfehlungen:
Aktualisierung der technischen Normen
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
