Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Concrete Sewer Manholes by the Negative Air Pressure (Vacuum) Test Prior to Backfill (Metric) (Withdrawn 2020)
Name übersetzen
NORM herausgegeben am 1.4.2017
Bezeichnung normen: ASTM C1244M-11(2017)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.4.2017
SKU: NS-680805
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
acceptance criteria, concrete, manhole sections, test method, vacuum test,, ICS Number Code 23.040.50 (Pipes and fittings of other materials)
Significance and Use | ||||||||
5.1 This is not a routine test. The values recorded are applicable only to the manhole being tested and at the time of testing. |
||||||||
1. Scope | ||||||||
1.1 This test method covers procedures for testing precast concrete manhole sections when using the vacuum test method to demonstrate the integrity of the installed materials and the construction procedures. This test method is used for testing concrete manhole sections utilizing mortar, mastic, or gasketed joints. 1.2 This test method is intended to be used as a preliminary test to enable the installer to demonstrate the condition of the concrete manholes prior to backfill. Users are hereby cautioned that misuse or misapplication of the test criteria contained herein can cause permanent damage to the system being tested. Note 1: Vacuum test criteria presented in this test method are
similar to those in general use. The test and criteria have been
widely and successfully used in testing manholes.
Note 2: It should be understood that no correlation has been
found between vacuum (air) and hydrostatic tests.
1.3 This test method is the companion to inch-pound Test Method C1244. 1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-05-17 (Zahl der Positionen: 2 902 148)
© Copyright 2024 NORMSERVIS s.r.o.