Cookies
Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
ASTM D1636-21
Standard Specification for Allyl Molding Compounds
Name übersetzen
NORM herausgegeben am 1.7.2021
Informationen über die Norm:
Bezeichnung normen: ASTM D1636-21
Ausgabedatum normen: 1.7.2021
SKU: NS-1031878
Zahl der Seiten: 3
Gewicht ca.: 9 g (0.02 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Kategorie - ähnliche Normen:
Die Annotation des Normtextes ASTM D1636-21 :
This specification provides for the identification of three types of allyl molding compounds, based on the general type of filler employed in their manufacture: Type I - High-strength materials, glass-fiber reinforced; Type II - General-purpose mineral filled; and Type III - General-purpose synthetic fiber filler. Types I and II may be subdivided into four classes according to resin composition and use as follows: Class A - Diallyl ortho-phthalate resin, nonflame-retardant; Class B - Diallyl ortho-phthalate resin, flame-retardant; Class C - Diallyl meta-phthalate resin nonflame-retardant; and Class D - Diallyl meta-phthalate resin, flame-retardant. Materials shall be compression molded, conditioned, and tested; and the individual grades shall conform to specified values of impact resistance, flexural strength, permittivity and dissipation factor, insulation resistance, flame resistance, and oxygen index.
Keywords:
allyl, diallyl phthalate (DAP), molding compounds-thermosetting,, ICS Number Code 83.140.99 (Other rubber and plastic products)
Ergänzende Informationen
| 1. Scope | ||||||||||||||||||
|
1.1?This specification covers compression molding, thermosetting, allyl compounds as further defined in Section 4. 1.2?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. Note 1:?The properties included in this specification are
those required to identify the molding compounds covered. There may
be other requirements necessary to identify particular
characteristics. These will be added to the specification as their
inclusion becomes generally desirable and the necessary test data
and methods become available.
Note 2:?There is no known ISO equivalent to this
standard.
1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||
|
Empfehlungen:
Aktualisierung der technischen Normen
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
