Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Staining Tendency of Asphalt (Stain Index)
Name übersetzen
NORM herausgegeben am 1.11.2018
Bezeichnung normen: ASTM D2746/D2746M-18
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.11.2018
SKU: NS-909265
Zahl der Seiten: 3
Gewicht ca.: 9 g (0.02 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Binders. Sealing materialsWaxes, bituminous materials and other petroleum products
Keywords:
asphalt, stain index, staining,, ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products),91.100.50 (Binders. Sealing materials)
Significance and Use |
4.1 This test method measures the tendency for oil components to separate spontaneously from asphalt. The separation of oil components can cause staining in asphalt roofing products and adjacent materials in storage and use. 4.2 The stain index is related to the thermal stability of the asphalt. Higher stain index values indicate lower stability and greater tendency for staining. 4.3 Use this procedure to determine the staining tendency of asphalt and to compare the results against a material for which the staining tendency is known. |
1. Scope |
1.1 This test method covers the determination of the staining tendency of asphalt and the assignment of a stain index proportional to the extent of staining observed. 1.2 This test method is applicable to asphalts having ring-and-ball softening points of 85°C [185°F] or greater. Note 1: This test method may be modified for use with other
bituminous materials with softening points less than 85°C [185°F]
by using a different temperature than specified in Section
7 by agreement of the
interested parties. The report of results from such a test may cite
this method but must clearly state the temperature employed in the
exception and acknowledge that the interpretation of results in
Section 9 and the precision
and bias stated in Section 10
may not apply.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-04-29 (Zahl der Positionen: 2 896 215)
© Copyright 2024 NORMSERVIS s.r.o.