Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Methods for Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods)
Automatische name übersetzung:
Standard-Prüfverfahren für die Messung von Hochdruckeigenschaften für Strömungs Schmierstoffe (Falex Stift und Block-Vee Methoden)
NORM herausgegeben am 1.12.2014
Bezeichnung normen: ASTM D3233-93(2014)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.12.2014
SKU: NS-580630
Zahl der Seiten: 11
Gewicht ca.: 33 g (0.07 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
extreme pressure, Falex Pin and Vee Block, load-carrying, lubricant, wear,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | |||||||||||||||||||||||||||||||||||||||||||||||
5.1 Evaluations by both test methods differentiate between fluids having low, medium, and high levels of extreme-pressure properties. The user should establish any correlation between results by either method and service performance. Note 3: Relative ratings by both test methods on the reference
fluids covered in Table 1 and
Table 2 are in good general
agreement with four-ball weld-point relative ratings obtained on
these same reference fluids, covered in Test Method D2783.
|
|
Repeatability |
|
|
|
|
Reproducibility |
|
|
||||||||||||||||||||||||||||||||||||||
|
|
s = 0.0624 |
|
|
|
|
S = 0.137 |
|
|
||||||||||||||||||||||||||||||||||||||
|
|
r = 0.179 (TL)E |
|
|
|
|
R = 0.391 (TL)E |
|
|
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines |
|
Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Four-Ball Method) |
|
Standard Test Method for Measuring Wear Properties of Fluid Lubricants (Falex Pin and Vee Block Method) |
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-05-06 (Zahl der Positionen: 2 897 584)
© Copyright 2024 NORMSERVIS s.r.o.