Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Estimating the Organic Fouling of Particulate Anion Exchange Resins (Withdrawn 2018)
Automatische name übersetzung:
Standard Test Methode zur Abschätzung der Organic Fouling von Particulate Anionenaustauscherharze
NORM herausgegeben am 1.5.2009
Bezeichnung normen: ASTM D5042-90(2009)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.5.2009
SKU: NS-29610
Zahl der Seiten: 3
Gewicht ca.: 9 g (0.02 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
anion resin, organic carbon, organic fouling, Contamination--water, Ion exchange resins, Organic compounds--water, ICS Number Code 71.100.40 (Surface active agents)
Significance and Use | ||||||||||||
One of the major factors in the unsatisfactory performance of anion exchange resins is their fouling by organic material. Knowledge of the degree of fouling can be used to assess the condition of the resin and may indicate the need for pretreatment of the influent, remedial cleaning procedures, or resin replacement. It is recognized that this test method may not remove and detect cation sloughage products or declumping agents. It is not intended to remove all organic compounds from the resin. Since the chemical structures of organics compounds fouling the resin are generally unknown and are expressed only on the basis of their carbon content, interpretation of test results to form a basis for predictions for resin performance or cleaning procedures should be approached with caution. Samples may be taken before or after plant regeneration, or both, depending on the type of information desired. This decision is left to the judgment of the user. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method provides a general estimate of the organic fouling of an anion exchange resin based upon total organic carbon measurements. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 8.3. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historisch
1.1.2014
Historisch
1.10.2009
Historisch
1.1.2014
Historisch
1.10.2009
Historisch
1.10.2009
Historisch
1.5.2009
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-05-05 (Zahl der Positionen: 2 897 047)
© Copyright 2024 NORMSERVIS s.r.o.