ASTM D5757-22

5.1?This test method is intended to provide information concerning the ability of a powdered catalyst to resist particle size reduction during use in a fluidized environment.

5.2?This test method is suitable for specification acceptance, manufacturing control, and research and development purposes.

1.1?This test method covers the determination of the relative attrition characteristics of FCC catalysts by means of air jet attrition. Other fine powder catalysts can be analyzed by this test method, but the precision of this test method has been determined only for FCC catalysts. It is applicable to spherically or irregularly shaped particles which range in size between 10 and 180 ?m, have skeletal densities between 2.4 and 3.0 g/cm³ (2400 and 3000 kg/m³) (see IEEE/ASTM SI-10) and are insoluble in water. Particles less than 20 ?m are considered fines. (See Terminology D3766.)

1.2?UnitsThe values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.