Cookies
Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
ASTM D5835-20
Standard Practice for Sampling Stationary Source Emissions for the Automated Determination of Gas Concentrations
Name übersetzen
NORM herausgegeben am 1.12.2020
Informationen über die Norm:
Bezeichnung normen: ASTM D5835-20
Ausgabedatum normen: 1.12.2020
SKU: NS-1013134
Zahl der Seiten: 9
Gewicht ca.: 27 g (0.06 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Kategorie - ähnliche Normen:
Die Annotation des Normtextes ASTM D5835-20 :
This practice presents the procedures and equipment that will permit, within certain limits, representative sampling of stationary source emissions for the automated determination of gas concentrations of effluent gas streams. This application is limited to the determination of oxygen (O2), carbon dioxide (CO2), carbon monoxide (CO), sulfur dioxide (SO2), nitric oxide (NO), nitrogen dioxide (NO2) and total oxides of nitrogen (NOx). Although velocity measurements are required to determine the mass flow rates of gases, this is, however, not included in this practice. This practice describes representative sampling of gases in a duct, both by extractive and non-extractive methods. In extractive sampling, gases are conditioned to remove aerosols, particulate matter, and other interfering substances before being conveyed to the instruments. In non-extractive sampling, the measurements are made in-situ; therefore, no sample conditioning except filtering is required.
Keywords:
automated stack sampling, dilution extraction, in-situ sampling, stack emissions, stack sampling,, ICS Number Code 13.040.40 (Stationary source emissions)
Ergänzende Informationen
| 1. Scope | ||||||||
|
1.1?This practice1.2?Velocity measurements are required to determine the mass flow rates of gases. This is not included in this practice. 1.3?There are some combustion processes and conditions that may limit the applicability of this practice. Where such conditions exist, caution and competent technical judgment are required, especially when dealing with any of the following: 1.3.1?Corrosive or highly reactive components, 1.3.2?High vacuum, high pressure, or high temperature gas streams, 1.3.3?Wet flue gases, 1.3.4?Fluctuations in velocity, temperature, or concentration due to uncontrollable variation in the process, 1.3.5?Gas stratification due to the non-mixing of gas streams, 1.3.6?Measurements made using environmental control devices, and 1.3.7?Low levels of gas concentrations. 1.4?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
| 2. Referenced Documents | ||||||||
|
Empfehlungen:
EEviZak – alle Gesetze einschließlich ihrer Evidenz in einer Stelle
Bereitstellung von aktuellen Informationen über legislative Vorschriften in der Sammlung der Gesetze bis zum Jahr 1945.
Aktualisierung 2x pro Monat!
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
