Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Tension Strength of Sew-Through Flange Buttons
Automatische name übersetzung:
Standard Test Method for Zugkraft von Sew-Through Flansch Tasten
NORM herausgegeben am 1.1.2013
Bezeichnung normen: ASTM D6644-01(2013)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.1.2013
SKU: NS-36003
Zahl der Seiten: 2
Gewicht ca.: 6 g (0.01 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
bridge of button, button failure, ICS Number Code 19.060 (Mechanical testing),59.020 (Processes of the textile industry)
Significance and Use | ||
5.1 This test measures an important property to users of sew through flange buttons. This is a means of determining the resistance of the bridge of the button to a strain which can cause it to fall off a garment to which it is attached. 5.2 If there are differences of practical significance between the reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, test samples should be used that are as homogeneous as possible, that are drawn from the material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing, Other materials with established test values may be used for this purpose. The test results for the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias. |
||
1. Scope | ||
1.1 This test method measures the resistance of the bridge of a sew-through button to a steadily increasing strain. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historisch
15.11.2012
Historisch
15.11.2012
Historisch
15.6.2009
Historisch
1.7.2010
Historisch
1.8.2013
Historisch
15.12.2011
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-04-24 (Zahl der Positionen: 2 895 425)
© Copyright 2024 NORMSERVIS s.r.o.