Standard Specification for Pyrolysis Liquid BiofuelName übersetzen
NORM herausgegeben am 1.10.2017
Bezeichnung normen: ASTM D7544-12(2017)
Ausgabedatum normen: 1.10.2017
Zahl der Seiten: 5
Gewicht ca.: 15 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
pyrolysis liquid biofuel, bio-oil, pyrolysis oil, pyoil, py-oil, bio-crude-oil, bio-fuel-oil, wood liquids, burner fuel, renewable energy, alternative energy, fuel oils, furnace oils,, ICS Number Code 75.160.20 (Liquid fuels)
1.1 This specification covers grades of pyrolysis liquid biofuel produced from biomass intended for use in various types of fuel-burning equipment under various climatic and operating conditions. These grades are described as follows:
1.1.1 Grade G is intended for use in industrial burners equipped to handle the pyrolysis liquid biofuels meeting the requirements listed for Grade G in . The pyrolysis liquid biofuel listed under Grade G in is not intended for use in residential heaters, small commercial boilers, engines, or marine applications.
1.1.2 Grade D is intended for use in commercial/industrial burners requiring lower solids and ash content and which are equipped to handle the pyrolysis liquid biofuels meeting the requirements listed for Grade D in . The pyrolysis liquid biofuel listed under Grade D in is not intended for use in residential heaters, engines, or marine applications not modified to handle these types of fuels.
Note 1: For information on the significance of the physical, chemical, and performance properties identified in this specification, see .
1.2 This specification is for use in contracts for the purchase of pyrolysis liquid biofuel and for guidance of consumers of this type of fuel.
1.3 Nothing in this specification should preclude observance of national or local regulations, which may be more restrictive.
Note 2: The generation and dissipation of static electricity may create problems in the handling of pyrolysis liquid biofuel. For more information on the subject, see Guide .
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4.1 Exception—BTU units are included for information only in .1.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2021-09-17 (Zahl der Positionen: 2 524 940)
© Copyright 2021 NORMSERVIS s.r.o.