Standard Test Method for Rubber Propertyâ€”Abrasion Resistance (Multi-Directional Platform Abrader)Name übersetzen
NORM herausgegeben am 1.5.2021
Bezeichnung normen: ASTM D8115-17(2021)
Ausgabedatum normen: 1.5.2021
Zahl der Seiten: 6
Gewicht ca.: 18 g (0.04 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
abrader, abrasion, abrasion resistance, frictional wear, mass loss, multi-directional platform abrader, rotary drum abrader, volume loss,, ICS Number Code 83.060 (Rubber)
|Significance and Use|
5.1Abrasion resistance is a performance factor of paramount importance for many rubber products, such as tires, conveyor belts, power transmission belts, hoses, footwear, and floor covering. A test capable of measuring resistance to abrasion of rubber, including uniformity of wear behavior under abrasive/frictional service conditions is therefore highly desirable.
5.2This test method may be used to estimate the relative abrasion resistance of different rubbers. Since conditions of abrasive wear in service are complex and vary widely, no direct correlation between this accelerated test and actual performance can be assumed.
5.3This test method is suitable for comparative testing, quality control, specification compliance testing, referee purposes, and research and development work.
1.1This test method covers the measurement of abrasion resistance of rubbers (vulcanized thermoset rubbers and thermoplastic elastomers) that are subject to abrasive/frictional wear in actual service. The abrasion resistance is measured by simultaneously moving 4 test pieces across the surface of abrasive sheets in a soft lissajous movement, and is expressed as volume loss in cubic millimeters where a smaller number indicates better abrasion resistance.
1.2Test results obtained by this test method shall not be assumed to represent the wear behavior of rubber products in actual service.
1.3Results obtained by this test have shown to be similar to those obtained using Test Method and ISO 4649.
1.4The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Bereitstellung von aktuellen Informationen über legislative Vorschriften in der Sammlung der Gesetze bis zum Jahr 1945.
Aktualisierung 2x pro Monat!
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2021-09-17 (Zahl der Positionen: 2 524 940)
© Copyright 2021 NORMSERVIS s.r.o.