Standard Practice for Sampling of Cannabis/Hemp Post-Harvest Batches for Laboratory AnalysesName übersetzen
NORM herausgegeben am 1.11.2020
Bezeichnung normen: ASTM D8334/D8334M-20
Ausgabedatum normen: 1.11.2020
Zahl der Seiten: 7
Gewicht ca.: 21 g (0.05 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
analyses, aseptic, cannabis, chain of custody, composite, hemp, homogeneity, inflorescence, laboratory, marijuana, representative, sampling,
|Significance and Use|
5.1This standard will provide best practices for the sampling of harvested cannabis inflorescence with the intent to assure representative sampling.
5.2The laboratory results and their respective harvest batch associations have implications and significance to regulatory requirements, quality control considerations throughout the products life cycle, and the safety of the consumers who may be adversely affected by consumption of product that was not tested in a homogeneous manner 5.3This standard does not address the appropriate sampling of processed cannabis materials such as such as extracts, seeds, edibles, topicals, etc.
5.4This standard addresses the sampling of cannabis inflorescence destined for human or animal consumption.
5.5This standard does not address pre-harvest field sampling or large untrimmed or unprocessed harvest batches.
1.1Cannabis harvested materials require sampling strategies throughout their life cycle, from cultivation to the end consumer. For purposes of this standard, the term cannabis is inclusive of all cannabis inflorescence, including hemp varieties. The qualitative and quantitative characteristics of cannabis/hemp for human or animal consumption has safety implications throughout the life cycle from cultivation to end consumer. This standard provides best practice procedures and protocols for sampling batches of harvested cannabis inflorescence. Cannabis/hemp materials often exhibit variability across different parts within the same plant or across different plants within the same cultivar, or both, 1.2Where procedural aspects of this practice differ from local regulatory or jurisdictional requirements, the local regulatory or jurisdictional authoritys directives shall take precedence.
1.3UnitsThe values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Letzte Aktualisierung: 2021-09-17 (Zahl der Positionen: 2 524 940)
© Copyright 2021 NORMSERVIS s.r.o.