Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Determination of Titanium in Iron Ores and Related Materials by Diantipyrylmethane Ultraviolet Spectrophotometry
Automatische name übersetzung:
Standard Test Methode zur Bestimmung von Titan in Eisenerze und verwandten Materialien durch UV-Spektrophotometrie Diantipyrylmethane
NORM herausgegeben am 1.8.2012
Bezeichnung normen: ASTM E878-12
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.8.2012
SKU: NS-48346
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
diantipyrylmethane, iron ore, photometric titanium, spectrophotometry, titanium, ICS Number Code 73.060.10 (Iron ores)
Significance and Use | ||||||||||||||
This test method is intended to be used for compliance with compositional specifications for titanium content. It is assumed that all who use these procedures will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices must be followed such as those described in Guide E882. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method covers the determination of titanium in iron ores, concentrates, and agglomerates in the compositional range from 0.01 % to 6.0 % titanium. Note 1—As used in this test method (except as related to the term relative standard deviation), percent or “%” refers to mass fraction (wt/wt) of the form g/100g. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This test method has been evaluated in accordance with Practice E1601 and Guide E1763. Unless otherwise noted in 13, the lower limit in the scope of each method specifies the lowest analyte content that may be analyzed with acceptable error (defined as a nominal 5 % risk of obtaining a 50 % or larger relative difference in results on the same test sample in two laboratories). 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historisch
1.6.2012
Historisch
1.10.2013
Historisch
1.10.2013
Historisch
1.9.2011
Historisch
1.6.2012
Historisch
1.10.2013
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-04-24 (Zahl der Positionen: 2 895 425)
© Copyright 2024 NORMSERVIS s.r.o.