ASTM F771-99(2005)

Fed. Std. No. 123

Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.

MIL-STD-129

Marking for Shipment and Storage

D1600-18

Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)

D1599-18

Standard Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings

D1598-23

Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure

D1505-18

Standard Test Method for Density of Plastics by the Density-Gradient Technique

D1248-16

Standard Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable

D1238-23a

Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer (Includes all amendments and changes 12/6/2023).

D2609-21

Standard Specification for Plastic Insert Fittings for Polyethylene (PE) Plastic Pipe

D2683-20

Standard Specification for Socket-Type Polyethylene Fittings for Outside Diameter-Controlled Polyethylene Pipe and Tubing

D2837-22

Standard Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials or Pressure Design Basis for Thermoplastic Pipe Products

D3035-22

Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Controlled Outside Diameter

D3261-24

Standard Specification for Butt Heat Fusion Polyethylene (PE) Plastic Fittings for Polyethylene (PE) Plastic Pipe and Tubing

D3350-21

Standard Specification for Polyethylene Plastics Pipe and Fittings Materials

F412-23

Standard Terminology Relating to Plastic Piping Systems

D2122-22

Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

D2239-22

Standard Specification for Polyethylene (PE) Plastic Pipe (SIDR-PR) Based on Controlled Inside Diameter